Microwave Data Systems MDS entraNET 2400 Instalační příručka stáhnout pdf (Strana 10)

System Part Number: 900-0782-81, -91

Document P/N: 551-0782-81, Rev C1

December 2014

Installation Guide

Hit <ESC> for the previous menu, then type ‘B’ for the Advanced Configuration. Select ‘B’ for

Direct Mode.

Direct Mode Menu as shown at the UHF Telemetry Transmitter end.

Selection Item Description – For UHF Telemetry Transmitter, RF Repeater end.

A DEFAULT Factory setting: Default direct state is direct mode

B MODE Factory setting: Enter direct mode

C TYPE Factory setting: Operate as the single root remote.

D NETADDR

All units on the same network must use the same address. Both ends of the

RMAS-120-81 UHF Telemetry Link must use the same address. Make same as entered

on the Basic screen.

E PWR +20 to +30 dBm in 1 dB steps. Setting carries over from basic menu.

F BAND 2400 MHz only, select A, B or C. Transmitter and Receiver must match.

Direct Mode Menu as shown at the

UHF Telemetry Receiver end.

Peninsula Engineering Solutions, inc. Telephone +1 925 837-2243

POB 1095 Facsimile +1 925 837-2298

Danville, California 94526, USA Internet www.peninsulaengineering.com

1 2 ... 5 6 7 8 9 10 11 12 13 14 15

Žádné komentáře

Microwave Data Systems MDS entraNET 2400 Instalační příručka Strana 10