
System Part Number: 900-0782-81, -91
Document P/N: 551-0782-81, Rev C1
December 2014
Installation Guide
Peninsula Engineering Solutions may change specifications as necessary to meet industry requirements. © 2014 Peninsula Engineering Solutions, inc.
Antenna Kit
If an antenna kit from PESi was supplied,
install the included lightning arrestor at the
bottom of the RF Repeater enclosure. Punch
or drill a 5/8-inch diameter hole for the Type
N(f) connector and mounting bracket.
Locate the hole toward the left side as
viewed from the front. Be sure the internal
antenna cable jumper will reach the hole
location. Follow the installation directions
supplied with the lightning arrestor.
Figure 4, UHF Tx
Lightning Arrestor,
at bottom of
RF Repeater
enclosure
Connections
UHF & RMAS Tx Assy Connect to:
UHF Antenna Jumper,
Type-N(m), Fig. 3
UHF Antenna feedline,
Type-N(f)
(Lightning Arrestor)
Door on Screw Terminal
Block
Wht/Blu/Blk
Wht/Blk/Slt
Repeater Door Switch
cable, (no polarity).
Wht/Grn/Blk
Wht/Yel/Blk
RF Power Monitor F1 F1 BNC coax cable
RF Power Monitor F2 F2 BNC coax cable
J1 Adapter Cable, 20 Pin Repeater Alarm Cable, P1
Waveguide Pressure
Sensor
RMAS TX Internal TB-1
IN - 5
IN - 4
Waveguide Pressure
Sensor Cable
(no polarity)
Green
Blue
Temperature Sensor
RMAS TX Internal TB-1
C – 3
B – 2
A – 1
Temperature Sensor
Cable
Yellow - C
White - B
Black - A
Caution!
Once battery is connected, the UHF Transmitter will
begin transmitting.
Battery A+ 12 VDC or
8.5 VDC
DC Power Cable with
3-pin plug P1 is attached
to the RMAS Tx TB-1 and
connects to the RF
Repeater Aux DC
connector located on the
repeater door.
12V repeaters = P6
24V repeaters = P7
Battery B+ 12 VDC or
8.5 VDC
Figure 5, Screw Terminal Block TB-1,
UHF Tx with P1 DC Power Cable
Note the PWR and LINK LEDs on the MDS
Transmitter. Both should be ON
.
Peninsula Engineering Solutions, inc. Telephone +1 925 837-2243
POB 1095 Facsimile +1 925 837-2298
Danville, California 94526, USA Internet www.peninsulaengineering.com
Komentáře k této Příručce